Before Starting PrintShot

Before you can start the PrintShot process in PatternSmith, make sure:

1. The Vision System is connected. To check this, go to File – Preferences – Vision System and click on IP Address to verify the connection. If not already done, you can calibrate here as well.

2. There is only one pattern in the project. If there is more than one pattern in the project, PrintShot will not work.

3. All the Register Markers in the PrintShot pattern are set as a Register Marker. Check this in the Project Editor. Select one of the Register Markers and on the right side, Register Marker should be selected as Yes.